Instruction Manual
⚫ Do not use the product without installing of the rubber feet.
⚫ Please install the rubber feet on the device
4. Installation location requirements
⚫ The product must be placed in accordance with the instructions in a solid place.
⚫ Put your product in a place easy to connect wires and easy normal maintenance.
⚫ Departure from the walls or obstacles with distance of 10 cm.
⚫ All of the oven must be placed above the solid table or rack device.
⚫ If the product is placed in the wall place, keep away from combustibles material.
⚫ Installed your product in a well ventilated, equipped with a good fire extinguishing equipment.
5. Removed the film adhesive on the surface of product before use.
6. Electrical Connection
⚫ The connection of the power cord must be in accordance with electrical safety standards.
⚫ Check the voltage and frequency, see if they comply with the request parameters on the product
nameplate before connecting.
⚫ A bipolar switch must be installed between the product and the power cord. When the machine
is in the load operation, the voltage error does not exceed ± 10%.
7. Power Cord Connection
⚫ Use an appropriate screwdriver to firmly fasten and fixed the cable.
8. Water Inlet connection
9. Use the water inlet pipe to connect water taps with electromagnetic valve inlet which on the rear of
the box, and add a filter on fitting end of water pipe against blocking of the electromagnetic Valve.
10. Excess steam will be discharged from the exhaust pipe, which on the back of the oven.
Attention
⚫ This product must be connected to the ground in safely before use
⚫ When connecting the power cord, please operate as shown figure: Insert copper bridges and
power lines under the screw, carefully tighten the power cord and make the copper bridge rest on
the power cord firmly.
⚫ If the connection is improper, it may cause joint heating, and burn off power cord.
⚫ The voltage of power supply on this equipment must agree with the voltage of power supply on
the product card.
⚫ Behind the furnace is equipped with a grounding screw, the copper wire should not be less then
1.5M ㎡, and it should be securely connected with ground which meet the safety requirements.
⚫ After installation, you should check all wiring for loose ends, whether voltage is normal, and
whether the safety connect ground is credible.
⚫ Fixed wiring of the device must be connected with all-pole disconnect switch according to wiring
rules. And on each pole switch should have at least 3mm contact separation, and suggest
installing earth leakage protection switch. For easy operation, not allowed to pile up things in
front of switch.
⚫ Do not store any flammable items in the vicinity of the installation location. Ambient temperature
is lower then 45℃, relative humidity is below 85%.
Special Remarks
1. Not suitable for home use. This product is a commercial machine to be operating by a trained chef.
2. it can not be shaken and tilting when operation.
To Next Page
Loading...