Adexa YXD-8A - Routine Inspection; Cleaning and Maintenance

Instruction Manual
⚫ Clockwise twist the timer knob and set the desired time. (Time Range between 0-120 minutes)
⚫ Clockwise twist hot air circulation thermostat knob and set the desired temperature, then the
temperature lights will be on. (Temperature range between 0 ~ 300 ℃)
⚫ When the temperature reach to the fixed one, the temperature light will be off.
⚫ The electro thermal tube stops heating.When the temperature drops a little, the temperature light
turn on, the thermostat will switch on the power automatically.
Spray Lamp
6. Spray device operation
⚫ This spray device is used accompany with hot air circulation device. The spay will turn into water
vapor in the hot stove.
⚫ When using the spray function, the lowest temperature in the furnace to reach 120 degrees
⚫ Press steaming fog switch( the spray light will be on), spay into inside chamber and hit the
heating pipe through the fan, and generate hot steam.
⚫ Amount of steam depends on the time you holding down the switch, but not more than 5 seconds.
⚫ The required spray volume is based on the cooking food and the amount of food, and can be
controlled.
Remark:
This spray device is used accompany with the timer and hot
air circulation device.
5. Routine Inspection & Cleaning and Maintenance
5.1 Routine Inspection
⚫ Always conduct routine inspections. Always check the products, and serious accidents can be
avoided.
⚫ When circuit or machines at failure, stop using.
⚫ Pay attention to check the status of machines before and after use everyday.
⚫ Check and see whether the machine is tilted.Whether control panel is broken before using.
⚫ Check whether there are aging, cracked or broken wires.
⚫ Check whether there is peculiar smell,offensive smell or vibration noise.
⚫ Check and see whether temperature is under controlled, whether there is leakage
phenomenon.Whether power is normal?
5.2. Cleaning and Maintenance
⚫ Cut off the power before maintenance. Make sure the oven is cooling down
⚫ when cleaning.
⚫ Clean up residual oil and residues in oven regularly to keep the inside of oven and furnace clean.
It is not allowed to use acidic cleaner.
⚫ Removed the racks or trays from inside chamber and put into water with cleaner.And use dry
cloth to clean inside chamber first, then use wet cloth.
⚫ It is not allowed to use water to spray it directly, prevent moisture infiltration to damage electrical