ADJ Products, LLC - www.adj.com - 12PX Hex/12PX Hex Pearl User Manual Page 16
12PX Hex/12PX Hex Pearl Operating Instructions
MANUAL MODE:
1. Press the Mode button until one of the following is displayed: R-xxx, G-xxx, B-xxx, u-xxx, A-xxx, or
U-xxx. The letter represents the color option that was last selected, and xxx is a 3-digit number that
represents the intensity setting that was last selected.
2. Press the Enter button to cycle through the options listed below:
• R-xxx = Red
• G-xxx = Green
• B-xxx = Blue
• u-xxx = White
• A-xxx = Amber
• U-xxx = UV
3. Press the Up and Down button to select the intensity level of the selected color. Selectable values
range from 000 to 255.
COLOR MACROS MODE:
1. Press the Mode button until C-xx is displayed. xx is a 2-digit number that represents the color
macro that was last selected.
2. Press the Up and Down button to select the desired color macro. Selectable values range from 01 to
64. Please see the Color Macros Chart section of this manual for a detailed list of color macros.
BUILT-IN PROGRAM MODE:
1. Press the Mode button until one of the following is displayed: P-xx, F-xx, or S-xx. The value dis-
played will depend on the option that was last selected.
2. Press the Enter button until P-xx is displayed. Then use the Up and Down buttons to select the
number of the desired program. Selectable values range from 01 to 07. Please refer to the System
Menu section of this manual for descriptions of each program.
3. Press the Enter button again until F-xx is displayed. Then use the Up and Down buttons to set the
fade speed of the selected program, with 00 being the fastest setting and 30 being the slowest set-
ting. Please note that fade speed is disabled for programs 02, 04, 06, and 07.
4. Press the Enter button again until S-xx is displayed. Then use the Up and Down buttons to set the
change speed of the selected program, with 01 being the fastest setting and 30 being the slowest
setting. Please note the change speed is disabled for programs 06 and 07.
RF SWITCH:
1. Press the Mode button until RF-xx is displayed. xx will be displayed as either “of” or “on”.
2. Press the Up and Down button to select “of” or “on.”
• “of” disables the ability to control the device via remote control.
• “on” enables the ability to control the device via remote control.
SOUND SENSITIVITY:
1. Press the Mode button until So-xx is displayed. xx is a 2-digit number that represents the sound
sensitivity level that was last selected.
2. Press the Up and Down button to scroll to the desired sound sensitivity level. Selectable values
range from 00 to 30. Select 00 to turn sound sensitivty off.
To Next Page
Loading...
