ADJ 5PX HEX - Page 17

ADJ Products, LLC - www.adj.com - 5PX Hex/5PX Hex Pearl User Manual Page 16
5PX Hex/5PX Hex Pearl Operating Instructions
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The 5PX Hex/5PX Hex Pearl have 4 DMX modes: 6 Channel mode, 7
Channel mode, 8 Channel mode, and a 12 Channel mode. See page 11 for each modes DMX traits.
1. This function will allow you to control each individual fixture’s traits with a standard DMX 512
controller.
2. To run your fixture in DMX mode press the MODE button until “AXXX” is displayed. “XXX” represents
the current displayed address. Use the UP or DOWN buttons to select your desired DMX
address, then press the ENTER button to select your DMX Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes
are listed below:
• To run the 6 Channel Mode, press the MODE button until “Ch06” is displayed. This is the
6 Channel DMX Mode.
• To run the 7 Channel Mode, press the MODE button until “Ch07” is displayed. This is the
7 Channel DMX Mode.
• To run the 8 Channel Mode, press the MODE button until “Ch08” is displayed. This is the
8 Channel DMX Mode.
• To run the 12 Channel Mode, press the MODE button until “Ch12” is displayed. This is the
12 Channel DMX Mode.
4. Please see page 11 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections
to any standard DMX controller.
Sound Active Mode:
In this mode the 5PX Hex/5PX Hex Pearl will react to sound, and chase through the different colors.
1. Plug the fixture in and press the MODE button until “SoXX” is displayed. “XX” represents the
sound sensitivity level. Use the UP and DOWN buttons to adjust the sensitivity. “00” is the lowest
sensitivity, “30” is the highest.
Static Color Mode:
1. Plug the fixture in and press the MODE button until “C-XX” is displayed. “XX” is the color number
currently displayed.
2. There are 63 colors to choose from. Use the UP and DOWN buttons to find your desired color.
Dimmer Curve:
This is used to set the dimmer curve used with DMX mode. See the Dimmer Curve chart on page 19
for more information.
1. Plug the fixture in and press the MODE button until the DMX address is displayed.
2. Press the ENTER button until “dCXX” is displayed. This is the dimmer setting. “XX” represents
the current dimming mode.
3. Use the UP and DOWN buttons to find your desired dimmer curve. Press ENTER when you are
finished.
• dC00 - Standard
• dC01 - Stage
• dC02 - TV
• dC03 - Architectural
• dC04 - Theater