ADJ Products, LLC - www.adj.com - 5PX Hex/5PX Hex Pearl User Manual Page 15
5PX Hex/5PX Hex Pearl Operating Instructions
Control Panel Lock:
The control panel will lock itself after 30 seconds if nothing is pressed. To unlock the control panel,
press the MODE button for 3 seconds.
Operating Modes:
The 5PX Hex/5PX Hex Pearl has five operating modes:
• DMX control mode - This function will allow you to control each individual fixtures traits with a
standard DMX 512 controller.
• RGBWA + UV Mode - Choose one of the six colors to remain static or adjust the intensity of each
color to make your own color.
• Sound-Active mode - The unit will react to sound, chasing through the built in programs.
The sound sensitivity is adjustable
• Program Mode - There are 7 built-in programs to choose from. Color change and color fade
speeds are adjustable.
• Static Color Mode - There are 63 colors to choose from.
RGBWA + UV Dimmer Mode:
In this mode you can adjust the individual colors to make your desired color.
1. Plug the fixture in and press the MODE button until:
2. When “r.XXX” is displayed you are in Red dimming mode. Use the UP and DOWN buttons to
adjust the intensity. After you have finished adjusting the intensity, or if you would like to skip to
the next color, press the ENTER button.
3. When “GXXX” is displayed you are in Green dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
4. When “bXXX” is displayed you are in Blue dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
5. When “uXXX” is displayed you are in White dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
6. When “AXXX” is displayed you are in Amber dimming mode. Use the UP and DOWN buttons to
adjust intensity.
7. When “UXXX” is displayed you are in UV dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
Program Mode:
In this mode you can choose 1 of 7 programs to run
. The fade speed and program speed are both
adjustable.
1. Plug the fixture in and press the MODE button until “P-XX” is displayed. “XX” is the current
program number displayed.
2. Use the UP of DOWN button to find your desired program.
3. Press the ENTER button to adjust the fade speed, “00” being the slowest, “30” the fastest.
4. Press the ENTER button again to adjust the color change speed, “00” being the slowest, “30” the
fastest.
To Next Page
Loading...
