ADJ Products, LLC - www.adj.com - Bubbletron Go Instruction Manual Page 2
Unpacking:
Thank you for purchasing the Bubbletron Go by ADJ Products, LLC.
Every Bubbletron Go has been thoroughly tested and has been shipped
in perfect operating condition. Carefully check the shipping carton for
damage that may have occurred during shipping. If the carton appears
to be damaged, carefully inspect your xture for any damage and be
sure all accessories necessary to operate the unit have arrived intact.
In the event damage has been found or parts are missing, please con-
tact our toll free customer support number for further instructions.
Please, do not return this unit to your dealer without rst contacting
customer support.
Instructions:
The Bubbletron Go is a portable battery powered bubble machine
capable of creating hundreds of bubbles a minute. This unit comes
with a wired On/O remote control with a 25ft. cable. To optimize the
performance of this product, please read these operating instructions
carefully to familiarize yourself with the basic operations of this unit. Be
sure you understand these instructions completely before attempting
to operate this unit.
Customer Support:
ADJ provides a toll free customer support line, to provide set up and
installation help and to answer any question should you encounter
problems during your set up or initial operation. You may also visit us
on the web at www.adj.com for any comments or suggestions. Toll
free customer service hours are Monday through Friday 8:00 a.m. to
4:30 p.m. Pacic Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2610
E-mail: support@americandj.com
To purchase parts online visit http://part.americandj.com
Warning! To prevent or reduce the risk of electrical shock or re, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
attempt to make any type of repair yourself without the manufactures
consent, doing so will void your manufactures warranty. In the unlikely
event your unit may require service please contact ADJ customer sup-
port for further instructions.
Bubbletron Go Introduction
Bubbletron Go Operation
ADJ Products, LLC - www.adj.com - Bubbletron Go Instruction Manual Page 5
Filling the Tray Reservoir:
1. Place the Bubbletron Go on a at level surface.
2. The bubble juice tray is located in the front of the machine. Fill the
tray, using premium American DJ
® brand bubble juice. Make sure
that you do not ll the tray above the designated ll line. Filling
above the line will result in damage to the machine. After the usage,
please empty the remaining juice to prevent damage as well.
Operation:
Once the tray has been lled, place the unit on at level surface. Flip
the power switch to the “ON” position and watch the bubbles come
out by the hundreds. Be sure the unit remains in a level position to
avoid accidental leaking.
Remote Operation (Optional):
The unit may be used with an optional on/o remote that can be used
to power on the Bubbletron Go regardless of the setting of the units
power switch.
Remote Operation:
1. Plug the remote control into the unit.
2. Push the power button on the remote to the “ON” position, main
power will be indicated by a glowing red LED above the remote
power button.
Battery Recharge:
It will take about 6 hours to reach full charge. To recharge the battery,
plug the supplied power supply into the input on the rear of the unit
and plug the other end into a matching power supply. A red LED on the
the power supply will glow indicating that the unit is charging. When
the unit reaches full charge a green LED will glow.
To Next Page
Loading...
