What to do if ADJ DJ Equipment is not responding to DMX?
If your ADJ DJ Equipment isn't responding to DMX, make sure the DMX cables are properly connected and wired correctly. Pin 3 is typically 'hot,' but some DMX devices may use pin 2 as 'hot.' Also, verify that all cables are connected to the correct connectors, paying attention to the input and output connections.
Lists the key capabilities and functions of the Dotz Par.
Explanation of DMX as a universal control protocol for lighting.
Guidance on connecting multiple fixtures in a DMX chain.
Specifications for approved DMX data cables and their use.
Setting DMX address and channel mode for control.
Lists the key capabilities and functions of the Dotz Par.
Explanation of DMX as a universal control protocol for lighting.
Guidance on connecting multiple fixtures in a DMX chain.
Specifications for approved DMX data cables and their use.
Setting DMX address and channel mode for control.
Power| voltage | 100V~240V 50Hz/60Hz |
|---|---|
| power draw | 36W |
| fuse | 2Amp (125V) 1Amp (250V) |
Lighting| LEDs | 1 x 36W COB TRI LEDs |
|---|---|
| beam angle with lens cover | 25 Degrees |
| beam angle without lens cover | 60 Degrees |
Weight and Dimensions| weight | 5lbs./ 2Kgs |
|---|---|
| dimensions without bracket | 6.5” (L) x 4.5” (W) x 6.5” (H) |
| dimensions with bracket | 8.25” (L) x 4.5” (W) x 8.75” (H) |
To Next Page
