ADJ Products, LLC - www.adj.com - Dotz Par User Manual Page 19
Dotz Par Fuse Replacement
Locate and remove the the power cord, then locate the fuse holder inside the power socket. Insert a
flat-head screw driver into the power socket and gently pry out the fuse holder. Remove the bad fuse
and replace with a new one. The fuse holder has a built-in socket for a spare fuse, so be careful not
to confuse the spare fuse with the active fuse.
Dotz Par Cleaning
Due to fog residue, smoke, and dust, cleaning the internal and external optical lenses must be car-
ried out periodically to optimize light output.
Use a soft cloth to wipe down the outside casing.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog resi-
due, dust, dew).
Dotz Par Troubleshooting
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
Check that the DMX cables are connected and wired correctly (pin 3 is “hot”; on some other DMX
devices pin 2 may be ‘hot’). Also, check that all cables are connected to the right connectors, as the
order in which the in[uts and outputs are connected can affect operation.
Unit does not respond to sound:
Quiet or high pitched sounds will not activate the unit.
If problems are not resolved, contact ADJ Products, LLC for service.
1-800-322-6337
To Next Page
Loading...
