MAINTENANCE GUIDELINES
DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE!
Before performing maintenance, ensure that the power has been disconnected and unit has
cooled and is a safe temperature to work on.
If the drain valve is blocked, the cooler box and tank may need to be cleaned.
To clean the cooler box and water tank, please follow the following steps.
a) Open the top cover and take out the dry ice basket (1).
b) Loosen the three screws on the water inlet cover (2) and remove the water inlet cover.
c) Loosen the four nuts (3) and remove the water pressure plate (4).
d) Unscrew the nine screws of the upper partition (5) and remove the upper partition.
e) Remove the insulation board (6).
f) Unscrew the eight screws of the lower partition (7) and remove the lower partition.
g) Clean the water tank using clean water and a soft cloth.
h) Clean the dry ice basket with a soft cloth and keep the mesh open to ensure no clogging occurs.
i) Replace parts and basket in reverse order.
To Next Page
Loading...
