ADJ Starburst - System Menu Advanced Settings; Fixture Settings

Starburst System Menu Starburst System Menu
“OFF” to deactivate sound active mode.
3. Press ENTER to conrm.
SENS - In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until “SENS” is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN
buttons to adjust the sound sensitivity. 0 being the least sensitive, and
100 being the most sensitive.
3. When you have found your desired setting press ENTER to conrm.
DNST - This mode can be used as a precaution mode, that
in case the DMX signal is lost, interrupted, or power is lost,
the operating mode chosen in the setup is the running mode
the xture will go into when the DMX signal is lost. You can
also set this as the operating mode you would like the unit to
return to when power is applied.
1. Press the MENU button until “DNST” is displayed, and either
“MASL”, “BLND”, or “LAST” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to ash. Use the UP
or DOWN buttons to choose an operating mode you would like the unit
to start up in when power is applied or the DMX signal is lost.
• LAST - If the DMX signal is lost the xture will stay in the last DMX
setting. If power is applied and this mode is set, the unit will automati-
cally go into the last DMX set up.
• MASL (Master Slave) - If the DMX signal is lost or power is applied,
the unit will automatically go into Master Slave mode and run a built-in
show.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
3. Press ENTER to conrm your desired set up.
ADJ Products, LLC - www.adj.com - Starburst Instruction Manual Page 10 ADJ Products, LLC - www.adj.com - Starburst Instruction Manual Page 11
MANU - In this submenu you are able to test the different
functions; LEDs, dimmer, strobe, and motor.
1. Press the MENU button until “MANU” is displayed, press
ENTER.
2. Use the UP and DOWN buttons to scroll through the various
functions able for testing. Once you have found your desired
function you would like to test press ENTER.
3. After you have pressed ENTER, use the UP and DOWN but-
tons to adjust the values and test the function. To exit press the
MENU button.
LED - With this function you can have the LED display
turn off after 10 seconds.
1. Press the MENU button until “LED” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all times,
or “OFF” to switch to have the LED display switch o after 10 sec-
onds.
DISP - This function will reverse the display 180º.
1. Press the MENU button until “DISP” is displayed, press ENTER.
2. Press ENTER to “ip” the display. Press ENTER to “ip” it again.
Press ENTER when you have made your desired setup.
3. Press ENTER to conrm. To make you LED display reappear again
press any button.
FHRS - With this function you can display the running
time of the unit.
1. Press the MENU button until “FHRS” is displayed, press ENTER.
2. The running time of the xture will now be displayed. Press MENU
to exit.