The bicycle may fall off or slip off during transportation and consequently severe injury may be caused. The bicycle
should be protected from turning over, slipping off and falling off when transported by vehicles or public transportation
facilities.
Please transport the bicycle using certified luggage carrier.
If there is no luggage carrier, the bicycle must be placed in the trunk (it cannot be placed on the gearbox).
The design charging cycle of battery is about 500 times. After the batteries are charged for 500
times, the battery level will no longer reach 100% but about 60%. A charging cycle refers to that
the battery level increases from 0% to 100%. If the battery level increases from 99% to 100%, it is
not a complete charging cycle but only 1% of a complete charging cycle. Generally, a charging
cycle can last for more than two years.
When the battery level is 75%, the batteries can be stored for about three months. When the
battery level is 50%, the batteries can be stored for about two months.
In order not to reduce the service life of battery, please follow the steps below:
1.Charge the batteries when the battery level is 30%-50% after riding.
2.Ensure the batteries are not fully discharged.
It takes 5-8 hours (from 1%-100%) to charge the batteries after fully discharged.
To store the batteries for more than two months, please follow the steps below:
Take out the batteries.
Ensure no damage of battery case and other visible damages.
Charge the batteries before stored for a long time.
Store the batteries in a safe and dry place.
Store the batteries at a temperature of 5-20℃.
Prevent great temperature variation of battery.
Please do not store the batteries under sunlight or high temperature.
Please charge the batteries at least every two months.
Moisture, pollution or mechanical damage may cause short circuit and consequently a fire or battery explosion may be
caused.
Clean the motor and the controller using wet sponge from outside.
If the motor and the controller are immersed in water accidently, please pull out the plug immediately and disconnect
the motor and the battery. Consult the manufacturer before powering on the motor again.
Bicycle Maintenance and Repair
Battery Maintenance
Maintenance of Motor and Controller
Bicycle Transportation
Lubrication
Use light machine oil (20W)
Please remove dust before lubrication and remove lubricant after lubrication.
Part
Pedal
Chain
Underframe
Motor
Lubrication plan Recommend lubrication method
Every 6 months
Every 6 months
Every 6 months
Every 6 months
Contact professionals
Contact professionals
Apply 4 drops of machine oil to the joint between the pedal and the pedal spindle
Apply 1 drop of machine oil to every roller of the chain
While inflating the tires, please be sure to check the tire pressure.
Inflation Pressure
09
To Next Page
Loading...
