Endurance Test
Wipe for 15s using a piece of cloth with water and then wise for 15s using a piece of cloth with benzoline.
1.Warning 1-Like all mechanical parts, the power-assisted bicycle will be affected by wear and high stress.
Different materials and parts may respond to wear or stress fatigue differently. If the design life of a part
expires, the part may break down suddenly and consequently the rider may be injured. Any form of crack,
scratch or change in color of the highly stressed area indicates that the service life of the part expires and the
component should be replaced.
2.Warning 2-The user may not see impact damage of parts made from composite materials and the
manufacturer should explain the impact damage and its consequences. The parts made from composite
materials should be returned to them manufacturer for inspection or destruction and replacement.
3.The weighted A noise at ears of the rider should be less than 70dB (A).
4.The bicycle must not be tampered deliberately or refitted without authorization.
5.The manufacturer/seller does not assume any responsibility for damage arising from the user’s tampering
and the user should ask for help from professionals.
6.The child seat cannot be installed below the bicycle.
7.Be sure not to clean the bicycle using high pressure cleaner.
8.For minimum height and dimension of the saddle, please refer to the minimum insertion mark on the seat
post.
9.The total permissible load of the bicycle (including rider) is 120kg.
10.The bare weight of the bicycle is about 21.5kg.
11.The bicycle cannot be designed with a trailer.
Maintenance Plan
Interval Component Operation
After riding for a
long time or for at
least 150km
After riding for a
long time or for
10-20 hours
(high-intensity)
Bicycle chain
Finished bicycle
Clean the bicycle and lubricate the chain gently.
Remove excess oil using cloth.
Dispose of duster cloth in an environmental way.
Use commercially available detergent and lubricant.
Comply with safety instructions for similar products and
environmental regulations on relevant substances.
Inspect whether the bicycle is damaged.
Dismount the bicycle. When necessary, it should be
repaired by a qualified distributor.
After riding for
25km (high-inten-
sity) to 50km
(highway)
Finished bicycle
Inspect whether the bicycle is damaged.
Dismount the bicycle. When necessary, it should be
repaired by a qualified distributor.
When necessary
Frame, rim and
pedal
Remove dirt using suitable brush.
Clean components using wet cloth
and neutral soap solution.
11
To Next Page
Loading...
