The damaged parts (such as battery and electrical or electronic components) of the bicycle may produce toxic
substances or gases and consequently environmental poisoning may be caused.
1.Abandon waste batteries and electrical/electronic components of the bicycle according to laws and regulations.
2.Please comply with the manufacturer’s instructions during operation.
Avoid electric shock or explosion caused by improper operation of battery and charger.
1.Only the batteries attached can be used.
2.Be sure not to connect positive and negative poles of the batteries.
3.Protect the batteries from direct sunlight.
4.Please do not dismount or clean the batteries.
5.Only the charger attached can be used to charge the batteries.
6.The charger plug is used to cut off the power. Please ensure the power socket is close to the charger for
user-friendliness.
7.The charger can be used for 110-230V grounding receptacle only. Please be sure to prevent the charger from
water or any type of liquids.
8.Keep metal contacts clean and clean them using soft dry cloth when necessary.
9.Please do not charge batteries with damaged case and other obvious damages.
10.Please prevent the batteries from falling off.
11.Charge the batteries at a temperature of 10-45℃.
12.Use batteries to power the bicycle at a temperature of 0-45°C.
13.Ensure the charger is used by people without physical, sensory or mental disabilities only.
In case of obstacles, please carry the bicycle.
In case of damage, please inspect the bicycle at the distributor.
Avoidance of Damage to Bicycle
Avoid severe injury caused by damaged parts
looseness of reflector and light
The reflector can capture and reflect light of street light, car headlight and other light sources so that the rider is
easy to identify. The rider may be hard to identify if the reflector is damaged, bent or loose and consequently
severe injury or death will be caused.
To avoid such accidents, you should:
1.Request the distributor to replace the damaged, bent or loose reflector and the light.
2.Inspect the reflector and the light regularly.
Improper maintenance, repair and cleaning may result in severe injury or death.
1.Only activities set forth in the maintenance plan can be carried out.
2.Only commercially available lubricant and detergent can be used.
3.Only qualified distributor can carry out maintenance and repair.
Parts of the bicycle (brake and tire) may heat up during riding and burn injury may be caused by touching
these parts.
Cool hot parts down before use or wear thermal protection device.
Riding is a strenuous physical activity.
Please be sure to supply sufficient liquids. Please inspect the bicycle at the distributor.
Cold injury may be easily caused while riding in cold weather.
Please be sure to wear suitable clothes in cold weather, including face shield, mask and gloves.
Avoid severe injury caused by improper and cleaning
Avoid burn injury
Avoid dehydration while riding
Avoid cold injury
16
To Next Page
Loading...
