The power-assisted system should be furnished with batteries, which are installed in the
frame.
The batteries can be removed using the key and charged. Only the charger attached can be
used to charge the batteries.
Like most large batteries, lithium ion battery is a hazardous substance according to
transportation regulations. The bicycle cannot be transported before the battery pack is
installed. For air transportation, regulations on hazardous substances should prevail.
(Please comply with local transportation regulations)
The packing box of battery pack must be marked with Danger during transportation.
Battery pack
Controller
The bicycle is furnished with a controller to adjust the power, which is controlled using the
handlebar. The power of the controller is calculated according to preset speed, actual speed
and pedal stress. The maximum speed is 25km/h. Power is not supplied above the
maximum speed.
The bicycle is furnished with gearbox.
Meaning of the following terms is as follows:
1.Down shift means to shift to a lower gear so that it is easier to step on the pedal.
2.Up shift means to shift to a higher gear so that it is hard to step on the pedal.
The gearbox consists of the following parts:
1.The gear box or threaded chain wheel on the rear wheel
2.Rear gearbox
3.Tray/chain ring
4.Drive/driven chain
5.Shift level/gear lever
The gearbox shifts gears on the condition that the drive chain moves forward and is at least at tense state.
The user can select a suitable gear as appropriate.
The brake is used not only to stop the bicycle but also to control the speed. The maximum braking force of
the tires refers to the stress when the tires are “locked” (do not rotate) and slide. In case of tire slip, most
braking force will be lost and the bicycle will be out of control. Please brake gently and stop the bicycle
slowly, namely progressive braking skill, to prevent the tires from being locked.
1.Push the brake to the handlebar to increase the braking force gradually.
2.If the wheels are stuck, please release the brake so that the wheels can rotate and are not stuck.
Brake
Power-on or Power-off
Please turn on the display as follows:
Press and hold “ ” for about 3s.
Please turn off the display as follows:
Press and hold “ ” again for about 3s.
Motor
The motor of the bicycle directly acts on the rear wheel and helps the user step on the pedal. The user can
adjust the power of the motor using existing control system and select different grades of riding. The motor
enables the maximum speed of 25km/h.
Gearbox
The pedal is installed at the end of the two cranks. Step on the pedal and the chain rotates to drive the
chain wheel.
The folding bicycle is furnished with two folding pedals easy to fold and transport.
Pedal
04
8
To Next Page
Loading...
