EasyManuals Logo

ADT EZ User Manual

ADT EZ
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
SYSTEM TROUBLE ERROR CODES
TBL
Flashes /
Touchpad beeps
READY
Flashes
Trouble Condition Action
6 NONE Lost Key Mode This is a reminder that the system has been put into the lost key mode ([STAY] &
[AWAY] pressed simultaneously). While in this mode, the system can only be dis-
armed with your EZ-IFOB. When you have replaced or re-keyed your deadbolt,
press [STAY] & [AWAY] simultaneously again to exit lost key mode.
7 NONE Fire Zone Trouble A problem has been detected with the Fire zone. Call for service.
1 1 Wireless Receiver TBL
or EZ Touchpad TBL
A problem has been detected with the wireless receiver. Call for service.
2 2 Wireless Receiver Jam A problem has been detected with a wireless receiver. Call for service.
3 2-8 Wireless Transmitter
Low Battery
The battery in a wireless transmitter is low and should be replaced. This transmit-
ter is on the zone corresponding to the number of
READY
flashes. The replace-
ment battery for the GEM-TRANS2 door/window transmitter, GEM-PIR motion
detector and GEM-GB glass break detector is the Duracell DL123A 3 Volt Lithium
(2 required for the GEM-PIR and GEM-GB). The GEM-DT Dual Technology Sen-
sor requires 4 C cell Alkaline batteries.
Warning: Replace batteries only with the same
type as specified above. Use of another battery may present a risk of fire or explosion. Do
not recharge or disassemble battery, or dispose of in fire.
4 2-8 Wireless Transmitter
Supervisory Failure
A problem has been detected with a wireless transmitter on the zone correspond-
ing to the number of
READY
flashes. Call for service.
5 1-4 Wireless Smoke
Detector Low Battery
The battery in a wireless smoke detector is low and should be replaced. The
number of the smoke detector corresponds to the number
READY
flashes. The
replacement battery is the Duracell MN1604 9 Volt Alkaline (2 required).
Warning: Replace batteries only with the same type as specified above. Use of another
battery may present a risk of fire or explosion. Do not recharge, disassemble, or dispose of
battery in a fire.
6 1-4 Wireless Smoke
Detector Supervisory
Failure
A problem has been detected with a wireless smoke detector. Call for service.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ADT EZ and is the answer not in the manual?

ADT EZ Specifications

General IconGeneral
BrandADT
ModelEZ
CategorySecurity System
LanguageEnglish

Related product manuals