– 23 –
USING DEVICE COMMANDS
General
Information
Your system may be set up so that certain lights or other devices can be turned on or off by
using the device command from the touchpad. Ask your installer if this has been done in your
system. If programmed for your system, some devices may activate automatically upon certain
system conditions. In this case, the following commands can be used to override the device
activation. See your installer for a full explanation of this feature.
To activate
devices
ENTER SECURITY CODE THEN PRESS # + 7 + DEVICE NUMBER
+ # + 7 +
(Security Code) (Device Number)
Example:
7 2 9 6 then press #, then press 7, then enter the number representing
the device you wish to activate. See your installer for device numbers assigned for your system.
To deactivate
devices
ENTER SECURITY CODE THEN PRESS # + 8 + DEVICE NUMBER
+ # + 8 +
(Security Code) (Device Number)
Example:
7 2 9 6 then press #, then 8, then enter the number representing the
device you wish to deactivate. See your installer for device numbers assigned for your system.
Device Description Device Description
1 5
2 6
3 7
4 8
To Next Page
Loading...
Need help?
General
