Safewatch Pro 3000 System Manual
https://alpha.adt.com/help/63[11/12/2018 9:41:21 PM]
User Access Codes
Access Code Programming
User Access Codes/Security Codes
Your system allows for up to 45 different security codes for use by other users, however only the Master
User or the Partition Programmer can assign user codes to users. User codes can be used
interchangeably while performing functions, e.g., a system can be armed with one user’s code and
disarmed by another’s, with the exception of the guest user code.
Programming User Codes and Authority Levels
1. Assign an authority level to that user:
1. Master: Can perform all system functions and assign codes in both partitions. Can change
their own code using: Master code + [8]+02+new code + new code again.
2. Standard User: Can perform security functions in assigned partition only.
3. Arm Only: Can only arm the system, cannot disarm or do other functions.
4. Guest: Typically assigned to a babysitter or a cleaner, a guest can arm the system in the
assigned partitions, but cannot disarm the system unless the system was armed with this
code.
5. Duress: Intended for use when forced to disarm or arm the system under threat. When used,
the system will act normally, but will silently notify the Customer Care Center of your situation,
if that service has been provided.
6. Partition Programmer: Can do everything a standard user can do, plus assign user codes to
users in their partition.
2. Assign other attributes as necessary.
User Code Attributes
Code/Level Command String Notes
Add A User Touchpad will
beep once to confirm.
Mast/Prog code + [8] + user
no. + new user’s code
User 01 = installer; User 02 = master;
User 03 = part. 1 programmer; User 33 =
partition 2 programmer
Delete User Code Mast/Prog code + [8] + [user
no.] + [#] [0]
The user code and all attributes
programmed for this user number
(except for the assigned partition),
including any associated RF keys, are
erased from the system.
To Next Page
Loading...
Need help?
General
