Configuring SNMP Using the GUI SNMP in the NetVanta 1570
20 6AMCCG0018-29A
Configuring SNMP v1/v2 in the GUI
Step 1: Enable SNMP and Enter Your SNMP Community Secret
1. Navigate to SNMP > SNMPv1/v2c. Toggle the Mode button to on.
2. Specify the community secret established for your SNMP polling server in the field to the right of the
corresponding v1/v2c community and ensure the communities that you plan to use are enabled. There are
typically two community strings defined: one intended for read only access and one intended for read/write
access.
3. Select Apply to save your changes.
Step 2: Enable the SNMP security Models (firmware v20.12-4 and earlier)
This step is only needed for firmware versions v20.12-4 and earlier.
The security models are turned off by default in firmware versions v20.12-4 and earlier. These security models,
which need to be enabled for SNMP to work on the ASE device, must be enabled in the CLI. See Step 3:
Enable the SNMP security Models (firmware v20.12-4 and earlier) on page 10.
Configuring SNMP v3 in the GUI
NOTE
g
Select the circular question mark icon located at the top-right hand side of the blue menu bar
from any page in the GUI for detailed explanations of variables and valid character lengths for the
different entries.
NOTE
g
Select the circular question mark icon located at the top-right hand side of the blue menu bar
from any page in the GUI for detailed explanations of variables and valid character lengths for the
different entries.
To Next Page
Loading...
Need help?
General
