Need help?Do you have a question about the Advanced Instruments 4D3 and is the answer not in the manual?
General| Brand | Advanced Instruments |
|---|---|
| Model | 4D3 |
| Category | Test Equipment |
| Language | English |
Detailed specifications for the Model 3D3 Osmometer, covering electrical, performance, and physical attributes.
Detailed specifications for the Model 4D3 Cryoscope, covering electrical, performance, and physical attributes.
Information on how to contact Advanced Instruments for product support and service procedures.
Procedure for calibrating the 3D3 and 4D3 instruments using calibration standards.
Critical safety instructions for performing maintenance and servicing procedures on the instrument.
Procedures for cleaning the cooling assembly, including flushing and draining the system for optimal performance.
Procedure for cleaning the instrument's well and tubing to remove foreign matter.
Guide for using the alignment tool to properly align the mandrel, probe, and stir/freeze wire.
Guide for checking and resetting the stir/freeze wire amplitude for proper operation.
Instructions for adjusting the head position sensors for proper head-up/down detection.
Overview of the instrument's self-checks performed upon power-up and introduction to A/D tests.
Detailed steps for performing Analog-to-Digital tests to check probes and cooling assembly.
Lists common symptoms, explanations, and suggested actions for resolving instrument issues.
Step-by-step guide for replacing the block probe with part number 4D3340.
Instructions for replacing the clapper using part number 3C2241R.
Instructions for replacing the control board set or individual application/processor boards.
Procedure for replacing the cooling assembly, including draining the system.
Steps for replacing the cooling fan unit with part number 4D3360.
Instructions for replacing the display board and its associated harness.
Guide for replacing the EPROM chip, part number 716811R, which contains the instrument software.
Instructions for replacing the EPROM chip, part number 716824R, for specific serial suffix models.
Guide for replacing the EPROM chip, part number 716825R, for specific serial suffix models.
Procedure for replacing the instrument's fuses, specifying part numbers and voltage ranges.
Steps for replacing the head up or head down relay, part number 3D3109.
Instructions for replacing the heat transfer fluid pump assembly.
Procedure for replacing the fluid filter element.
Instructions for replacing the power supply assembly for different models.
Specific instructions for replacing the 4D3950 power supply.
To Next Page
