Installation
Please follow the precautions listed below
when setting up your printer. They are
designed to help you keep your printer work-
ing at its best.
• Plug your printer into an appropriate
grounded outlet.
• Place your printer on a flat hard surface,
like a tabletop.
• Keep your printer out of direct sunlight.
Connect the centronics cable to the 36-pin
centronics connector on the printer, and then
connect the DB25 cable to the female DB25
connector on the back panel of the instrument.
Connect the DIN cable to the printer power
jack on the back panel of the instrument, and
then to the DC input on the printer.
Installing the Paper
1. Remove the printer cover by pressing on
the groove pattern to pop the front edge
up. Lift off the cover.
2. Press the rocker switch to the left. The
light will go off.
3. Unroll several inches of the paper.
4. Cut a straight edge on the paper roll if it
is jagged. This will facilitate inserting
the paper into the printer.
5. Slide the paper through the slot between
the paper compartment and the printer
compartment. You can slide the paper in
about one-quarter inch before it stops.
6. While holding the paper in place, press
the rocker switch to the paper feed posi-
tion. The printer will activate, and a rub-
ber roller will pull the paper into the
printer compartment. Hold the switch in
the paper feed position until the paper
emerges from the top of the printer mech-
anism.
7. When an inch of paper has emerged from
the top of the printer, release the paper
feed button and pull the paper through the
printer until several inches are exposed.
8. Slide the paper through the slot in the
printer cover.
4MP540 Rev3
(4D35SM)
Page 2 of 7
To Next Page
Loading...
