Advantage S-150 - Front Panel; Standby; LED; Indicator

5
LED / Indicator
(2.)
When you turn on the master ON/OFF switch the LED will
flash until all circuits have reached full power. Given that
there are no problems with the Input Signal, such as high DC-
offset, the LED will after a few seconds have a steady light
indicating that the S-150 is in operation. If, however, the LED
starts to flash during operation it means most likely that the S-
150 is overheated. Try turning the master switch off for a
while and then turn it back on.
Standby
(1.)
For best results, the S-150 should be left on or in the standby
mode at all times. The unit should not be switched off via the
master ON/OFF switch unless the unit will not be being used
for a significant period of time (during vacations, etc.).
Front panel
ADVANTAGE
1.
STANDBY
2.
ADVANTAGE