Advantech ADAM-4017 User Manual

4-64 ADAM 4000 Series User's Manual
$AA9
Name CJC Offset Calibration
Description Calibrates an analog input module to adjust for offset errors of
its CJC (Cold Junction Compensation) sensors.
Syntax $AA9S(number of counts)(cr).
$ is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address of the analog input module which contains the CJC
Status you wish to retrieve.
9 is CJC Status command.
S sign, + or -, indicates whether to increase or decrease the CJC
offset value.
(number of counts) a four character hexadecimal “count” value.
Each count equals approximately 0.009° C. The value can range
from 0000 to FFFF.
(cr) is the terminating character, carriage return (0Dh).
Response !AA(cr) if the command is valid.
?AA(cr) if an invalid command was issued.
There is no response if the module detects a syntax error or
communication error or if the specified address does not exist.
! delimiter character indicates a valid command was received.
? delimiter character indicates the command was invalid.
AA (range 00-FF) represents the 2-character hexadecimal
address of an analog input module.
(cr) is the terminating character, carriage return (0Dh).
Example command: $079+0042(cr)
response: !07(cr)
The command increases the CJC offset value of the analog
input module at address 07h with 66 counts (42 hex) which
equals about 0.6° C.
NOTICE: An analog input module requires a maximum of 2 seconds to
perform auto calibration and ranging after it received an CJC Calibra-
tion command . During this interval, the module can not be addressed to
perform any other actions.
4011, 4011D, 4018, 4018+, 4018M, 4019

Advantech ADAM-4017 Specifications

General

Brand	Advantech
Model	ADAM-4017
Category	Control Unit
Language	English