4-112 ADAM 4000 Series User's Manual
Command Set
@AADA
Name Disable Alarm
Description Disables all alarm functions of the addressed analog input
module.
Syntax @AADA(cr)
@ is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address of an analog input module.
DA
is the Disable Alarm command.
(cr)
represents terminating character, carriage return (0Dh).
Response !AA(cr) if the command was valid.
There is no response if the module detects a syntax error or
communication error or if the specified address does not exists.
! delimiter character indicating a valid command was received.
AA
represents the 2-character hexadecimal address of the
responding analog input module.
(cr)
represents terminating character,
carriage return (0Dh).
Example command: @07DA (cr)
response: !07(cr)
The analog input module at address 07h is instructed to disable
all alarm functions.
The module confirms it alarm functions have been disabled.
NOTICE: An analog input module requires a maximum of 2 seconds
after it received an Disable Alarm command to let the settings take effect
. During this interval, the module can not be addressed to perform any
other actions.
4011, 4011D, 4012, 4014D, 4016
To Next Page
Loading...
Need help?
General
