4-120 ADAM 4000 Series User's Manual
Command Set
4016
$AA6
Name Get Excitation Voltage Output Value
Description The addressed strain gauge input module is instructed to return
the latest output value it received from Excitation Voltage
Output command. If the module hasn’t received an Excitation
Voltage Output command since startup, it will return its Start-
up Output value.
Syntax $AA6(cr)
$ is a delimiter character.
AA(range 00-FF) represents the 2-character hexadecimal
address of the strain gauge input module.
6 is the get excitation voltage output command.
(cr) is the terminating character, carriage return (0Dh)
Response !AA(data)(cr) if the command is valid.
?AA(cr) if an invalid command was issued.
There is no response if the module detects a syntax error or
communication error or if the specified address does not exists.
! delimiter character indicating a valid command was received.
? delimiter character indicating the command was invalid.
AA (range 00-FF) represents the 2-character hexadecimal
address of the strain gauge input module.
(data) is the value that is returned by analog output channel.
The format of the data is in engineering unit.
(cr) is the terminating character, carriage return (0Dh)
Example command: $0A6(cr)
response: !0A+03.000(cr)
The command tells the strain gauge input module at address
0Ah to return the last excitation voltage output value it
received from an Excitation Voltage Output command.
The strain gauge input module returns the value +03.000V.
To Next Page
Loading...
Need help?
General
