Chapter 4 Command Set 4-3
Chapter 4
Before the command set, we provide the I/O module commands search
table to help you find the commands you wish to use. The command set is
divided into the following four subsections:
• Analog Input Module commands
• Analog Output Module commands
• Digital I/O and Relay Output Module commands
• Counter/Frequency Module commands
Every subsection starts with a command summary of the particular type of
module, followed by datasheets that give detailed information about
individual commands.
Although commands in different subsections sometimes share the same
format, the effect they have on a certain module can be completely different
than they have on another. For example, the configuration command:
%AANNTTCCFF affects analog input modules and analog output modules
differently.Therefore, the full command set for every module is listed.
To Next Page
Loading...
Need help?
General
