ADAM-4570 Series User Manual 18
2.3 Configuration Utility Installation
In order to use a PC and an Ethernet network to control serial devices
connected to the ADAM-4570 Series, you must first have a host running
Windows 2000/XP/Vista. This type of application also requires the host
to have an Ethernet card and TCP/IP protocol installed. The following are
the required steps for ADAM-4570 Series:
1. Insert the Advantech IEDG series driver utility CD-ROM into the drive
(e.g. D:\) on the host PC. Change the host computer's default drive from
C: to D:
2. Use your Windows Explorer or the Windows Run command to execute
the Setup program (the path for the Setup program on the CD-ROM
should be on the CD-ROM should be:
D:\Utility&Driver\Serial Device Server Configuration Utility\Serial_
Device_Server_Configuration_Utility_[Version]_Release_[Date].exe
3. Upon executing the setup program, the Welcome Dialog Box will pop-
up. Press the "Next" button to continue.
Note:
Be sure that you have at least version 2.0 of the
Microsoft .NET Framework installed on your PC.
To Next Page
Loading...
