7 ASMB-784 User Manual
Chapter 1 Hardware Configuration
1.6 ASMB-784 Block Diagram
Figure 1.3 ASMB-784 Block Diagram
1.7 Safety Precautions
FDI
Lynx Point
Platform
Control Hub
(C226)
DMI
Intel LGA 1150
Haswell WS
Processors
Channel A
(ECC) DDR3 1066/1333/1600
(ECC) DDR3 1066/1333/1600
One PCIe x 16 slot
One PCIe x 16 slot
D
P
DP
Switch
PCIe
Level ShifterDVI
DVI
Level Shifter
Gen3 x8
PCIe Gen3 x8
PCIe Gen3 x8
Channel B
(ECC) DDR3 1066/1333/1600
(ECC) DDR3 1066/1333/1600
PCIe Gen2 x1
PCIe x 1
USB 2.0
PCIe x 1
PCIe x 1
Gen 2.0
PCIe x
1
G
en 2.0
PCIe x 1
Gen 2.0
PCIe x 1
Gen 2.0
One PCIe x 1 slot
PCIe Gen2 x1
One PCIe x 1 slot
R
G
B
USB 2.0
RGB
9 USB 2.0
USB 3.0
Audio Codec
ALC892
VGA D-Sub
6 SATA Ports with
RAID 0,1,5,10
4 USB 3.0
HD Audio
G-LAN1 :
Intel I217-LM (PHY)
G-LAN2 :
Intel I210-AT
G-LAN3 :
Intel I210-AT
G-LAN4 :
Intel I210-AT
ITE 8892F
2 RS 232
1 LPT
3 PCI slots
SPI Bus
LPC Bus
Winbond
83782D
LPC
Connector
BMC
Connector
(Optional)
SM BUS
NC-SI
128 Mbit
BIOS Flash
Nuvoton
NCT6776
Warning! Always completely disconnect the power cord from your chassis when-
ever you work with the hardware. Do not make connections while the
power is on. Sensitive electronic components can be damaged by sud-
den power surges. Only experienced electronics personnel should open
the PC chassis.
Caution! Always ground yourself to remove any static charge before touching the
motherboard. Modern electronic devices are very sensitive to static
electric discharges. As a safety precaution, use a grounding wrist strap
at all times. Place all electronic components on a static-dissipative sur-
face or in a static-shielded bag when they are not in the chassis.
Caution! The computer is provided with a battery-powered real-time clock circuit.
There is a danger of explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacturer.
Discard used batteries according to manufacturer’s instructions.
Caution! There is a danger of a new battery exploding if it is incorrectly installed.
Do not attempt to recharge, force open, or heat the battery. Replace the
battery only with the same or equivalent type recommended by the man-
ufacturer. Discard used batteries according to the manufacturer’s
instructions.
To Next Page
Loading...
