37 ASMB-784 User Manual
Chapter 3 BIOS Operation
3.3.5 SATA Configuration
Figure 3.9 SATA Configuration
SATA Controller(s)
This item is to enable or disable SATA devices.
SATA Mode Selection
Set as IDE, AHCI, or RAID when SATA Controllers are enable.
SATA Controller Speed
Sets the maximum speed of SATA controllers, and there are three modes, Gen1,
Gen2, and Gen3.
OROM UI Delay
When this item is enable, user is able to indicate the delay of the OROM UI Splash
Screen in a normal status.
Port 0~5
To enable or disable SATA port 0~5.
Port 0~5 Device Type
To identify the SATA is connected to Solid State Drive or Hard Disk Drive.
Port 0~5 Spin Up Device
On an edge detect from 0 to 1, the PCH starts a COMRESET initialization sequence
to the device.
To Next Page
Loading...
