Contents
1 Introduction 3
1.1 Product Selection an d Specification 3
1.2 Number Types 4
2 Numbers and Startup 5
2.1 Registration 5
2.2 Command Message Format 5
2.3 Master Number Setup 6
2.4 Allowing Master Control for All Users 7
2.5 Adding a User Number 7
2.6 Removing a User Number 7
2.7 Viewing the Valid Number List 8
2.8 Finding a Number in the Memory 9
2.9 Clearing All Numbers and Settings 9
2.10 Result Acknowledgement Message 9
3 General Setup 10
3.1 Input-Output Status Message 10
3.2 PAYG SIM Keep Alive 10
3.3 Signal Strength Indicator 11
3.4 Power Up/Reset Text Message 12
3.5 SIM Card Balance Checking and Service Data Forwarding 12
3.6 Forwarding SMS Messages to any Number 12
3.7 Inverting the Relay Output 13
3.8 Input A Relay Control 13
4 Relay Operation/Access Control 14
4.1 Enabling Any Number and Disabling Open-on-Call 14
4.2 Call Reject 14
4.3 Connecting a Call 14
4.4 Relay Activation Mode 15
4.5 Relay Activation Time 15
4.6 OPEN/ON & CLOSE/OFF Commands 15
4.7 Exit Switch Enable 16
4.8 Output Change Acknowledge SMS 16
5 Auto-Dialler/SMS Sender 17
5 Input Triggered SMS Text Sending and Auto-Dialling 17
5.1 Enabling and Disabling Inputs 17
5.2 Input Change State Level 18
5.3 Customising the Input Alert Message 19
5.4 Autodial Logic 19
5.5 Changing the Maximum Ring Time 19
5.6 Changing the Maximum Call Time 20
5.7 Changing the Maximum Silence Time 20
5.8 Adding SMS Sender Text Numbers 20
5.9 Adding Auto-Dialler Call Numbers 20
5.10 Assigning a Number to One Channel Only 20
5.11 International Calling/Texting 21
5.12 Dial Now 21
5.13 Input Hold-off Timer 21
5.14 Repeating the SMS/Call 21
5.15 Silencing the Alarm 21
6 Analogue Voltage Measurements 22
6.1 Setting the Upper Voltage Threshold Voltage 22
6.2 Setting the Lower Voltage Threshold Voltage 22
7 GPRS Software PC Connection 23
7.1 Specifying the Access Point Name (APN) 23
7.2 Initiating a PC Connection 23
8 Installation 24
8.1 Power Connection 24
8.2 Input Connection 25
6.3 Connection to a Burglar Alarm 25
6.4 Output Connection 26
6.5 Antenna Connection 27
6.5 Mounting 27
9 Command Set Summary 28
To Next Page
Loading...
Need help?
General
