10 SMS Command Set Summary
Command Action Comments
ACKNOWLEDGE DISABLE
ENABLE SMS on Relay Change State
ADD
number . Add User Number
APN “apn_name”
,“user” ,”password” Set Network APN
AUTODIAL OR
AND THEN
CALL LIST
ANY NONE Call Handling
CALLNUM(A/B)
number Add Autodial Call Number
CLEAR ALL
Factory Reset (CLEAR ALL)
CLOSE
Deactivate Relay
CONNECT NONE
CL OP Connect Call Condition
CSQ
Get RSSI
CTIME <seconds>
. Set Call Maximum Time Limit
CUSTOM
Custom input message
DIAL
number Dial Number on Receipt
DIVERT ENABLE
DISABLE Enable Dialling Diverted Calls
EXIT DISABLE
ENABLE Exit Switch Enable
FORWARD
DISABLE ENABLE TEMP Forward SMS/SSD
HOLDX
<seconds> <minutes>m. R 0 Input Delay
INPUTX BOTH
AUTO TEXT INPUT Control (4.1)
INPUTX
DISABLE
INLEVELX CLOSE
OPEN BOTH Input Edge (4.2)
IP
“x.x.x.x” ,“x” Connect to IP Address
KA
number frequency Keep Alive Message
LIST
List All Numbers
MASTER
number . Add Master User
MUSER DISABLE
ENABLE Treat all users as Master
OFF [as CLOSE}
Deactivate Relay
OPEN/ON
<minutes>m. Activate Relay (with Time)
PSMS ENABLE
DISABLE Power Up Text Alert
QUERY/QNUM
number . Find Number in Memory
REJECT
ALL
NEVER
OPEN Call Handling
REMOVE(C/D/M/T)
number . Remove Number
RESET
Remote Restart
REPEATX
<seconds> <minutes>m DISABLE Repeat Dialling/Sending
RLYMODE PULSE
TOGGLE RING Relay Mode Toggle/Pulse
RLYTIME
<seconds> (default 3s)
RLYTIME
<minutes>m . relay time in minutes
RSMS ENABLE
DISABLE Reset Text Alert (Network)
RTIME
<seconds> Maximum Ring Time
SILENCE
Silence Alarm—Activate Relay
STIME
<seconds> Maximum Line Silence Time
SMS
number, message . SMS Text Forwarding
STATUS
Get Relay and Input Status
TEXTNUM(A/B) <master>
number . Input Trigger Text Numbers
TEXTRES DISABLE
ENABLE Result Acknowledgement
VLOWERX
x (0V) x.x xx.x Lower Threshold Voltage
VUPPERX
x (36V) x.x xx.x Upper Threshold Voltage
NORMALLY OPEN
CLOSED Invert Relay
DTMF
2 1-9 DTMF Discrimination
To Previous Page
Loading...
Need help?
General
