27
...... this does not necessarily mean that a fault
has occurred.
When pung into service, a bright
display appears
Regular funconing NOTHING: everything is normal
When pung into service, your
installaon short-circuits
The connecon of you device is
defecve
Verify your connecon or the
conformity of the connecon
The venlaon connues a few
minutes aer stopping the device
Cooling of the device It’s normal
The device doesn’t work. The
display on the casing stays o
The device is not supplied. The
supply or the connecon is
defecve
Inspect fuses and the circuit
breaker of your electric installaon
« F- » appears on the power or
temperature display
There is a touch acvated
permanently on the control
keyboard
If the default doesn’t disappear,
call the aer-sales service
« F7 » appears on the power or
temperature display
Electric circuits are over heang
Inspect the venlaon of the
device and check if it is operaonal
The device doesn’t work
« Fx » appears on the display
Electric circuits doesn’t work well
Unplug and replug the device.
Problem already present
-
Aer switching on the device and
starng the cooking zone, the
selected indicator connues to
ash
The pan you are using is not
compable with the inducon
techhnology or is of a diameter
smaller than 12 cm
See « Cookware Recommended
secon »
Pan makes noise while cooking
It’s a vibraon generated byy the
circulaon of the current in the pan
This phenomenon is normal with
some type of pans. There is no
danger
The device releases a smell during
the rst cookings
New device
Run the cooking during half an
hour with a pan full of water
-
To Next Page
Loading...
