How to install your induction hob.
R emove the packaging material.
Free the electricity supply flex from under the
appliance and unroll it fully.
A space of 5 cm should be left between the wall
and the appliance.
Do not fit your hob below a shelf or near inflam-
mable material, such as curtains, draperies, etc…
Plug your hob into a 16 ampere earthed (For hobs
with a United K ingdon S ocket plug type : a 13 am-
pere earthed socket has to be use) socket. If you
use an extension lead check that it complies with
standards (earth connection, cross section of
conductor = 1.5 mm²).
The plug must remain accessible.
Do not move your appliance while it is working.
When your appliance is turned on, an indicator light
may appear.
This code is reserved for the technical department,
and does not concern the user.
It goes off itself after about 30 seconds or when any
button on your appliance is pressed.
Your applianc e s hould be placed on a clean, ho-
rizontal, flat, stable s urface which is heat proof
or else coated with a heat proof material.
The air inlet under the appliance should not be
blocked (e.g. paper, cloths, etc.).
About
once a month, clean the filter, located under your
appliance, with soapy water.
When it is completely dry put it back in place be-
fore using the appliance.
This filter is es s ential
. It protects your appliance
from dust and fat.
VE R Y IM P OR
T
ANT
WAR NING
MAINT E NANC E
C LEAN THE FILTER
To open unscrew the screw
21
To Next Page
Loading...
Need help?
General
