www.aeg-automotive.com
20
Using the LED light
Set the switch (4) to the “I” position to
switch on the LED light on the clamps.
Set the switch (4) to the “0” position to
Disconnecting
Note:
before disconnecting the jumper leads
the rear and front defrost should be
switched on in the vehicle with the
vehicle lights). This will reduce possible
voltage spikes whilst disconnecting and
prevent damaging electrical parts.
Disconnect the terminal clamps in the
following order:
Caution!
contact with the moving parts of the
engine.
1. Negative lead (black) from earth
2. Negative lead (black) from negative
3.
After jumpstarting drive the broken-
down vehicle for a longer distance
3
3
2
1
To Next Page
Loading...