• The programme is completed (sequence
of sounds for about 1 minute).
• The appliance has a malfunction
(sequence of short sounds for about 5
minutes).
To deactivate/activate the acoustic signals
set a one of the programme, touch the Temp.
and the Spin buttons simultaneously for about
2 seconds. The display shows On/Off
If you deactivate the acoustic signals,
they continue to operate when the
appliance has a malfunction.
10.2 Child Lock
With this option you can prevent children from
playing with the control panel.
To activate/deactivate this option, hold down
the Easy Iron button until comes on/goes
off on the display.
The appliance will default to this option after
you switch it off.
The Child Lock function may not be available
for a few seconds after switching the
appliance on.
10.3 Operating Hours Counter
It is possible to visualise the total operating
time of the appliance in hours, starting from
the first switching on. This value will count
operating time of the cycles (does not include
pauses, delayed start time). To visualise this
value, proceed as follows:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the Eco
40-60 programme (1st position
clockwise).
3. Press and hold the Spin and Temp.
buttons for some seconds (within 10
seconds after the switching on. After
these 10 seconds, the key combination
activates and deactivates the acoustic
signals).
4. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens and
units).
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
10.4 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the
Synthetics programme (3rd position
clockwise).
3. Press and hold the Spin and Temp.
buttons for some seconds (within 10
seconds after the switching on. After
these 10 seconds, the key combination
activates and deactivates the acoustic
signals).
4. The display will show
for about 5
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
11. BEFORE FIRST USE
1. Make sure that the electrical power is
available and the water tap is open.
2. Pour a small quantity of detergent into the
compartment marked by .
3. Set and start a programme for cotton at
the highest temperature without any
laundry in the drum.
This removes all possible dirt from the drum
and the tub.
ENGLISH 19
To Next Page
Loading...
