If a selection is not possible an acoustic
signal sounds.
12.6 Starting a programme
Touch the Start/Pause button to start the
programme. It is not possible to start the
programme when the indicator of the button
is off and doesn't flash (e.g. programme dial
on a wrong position).
The related indicator stops flashing and stays
on.
The programme starts, the door is locked.
The display shows the indicator .
The drain pump can operate shortly
before the appliance fills water.
12.7 Starting a programme with the
delay start
1. Touch the Delay Start button repeatedly
until the display shows the desired delay
time. On the display the indicator shows
2. Touch the Start/Pause button. The
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator .
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button repeatedly
until the display shows
and the
indicator goes off.
3. Touch the Start/Pause button again to
start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button repeatedly
until the display shows the desired delay
time.
3. Touch the Start/Pause button again to
start the new countdown.
12.8 The AutoSense System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause button, the
AutoSense System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
Time Save
is available, during this
phase the two dots separating hours from
minutes are blinking and the drum rotates
shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The AutoSense detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced.
22 ENGLISH
To Next Page
Loading...
