AEG 5000 Series User Manual

CAUTION!
Make sure there is no damage to hoses
and there are no leaks from the
couplings. Do not use an extension hose
if the inlet hose is too short. Contact the
service centre for information on inlet
hose replacement.
1. Connect the water inlet hose to the back
of the appliance if needs. Usually, it is
already installed at the factory.
20º20º
45º45º
2. Position it toward left or right depending
on the positon of the water tap. Make
sure that the inlet hose is not in vertical
position.
3. If necessary, loosen the ring nut to set it
in the correct position.
4. Some model can contain inlet hose with
water stop device. It prevents any leaks in
the hose because of its natural ageing.
The sector in the window shows this fault
A. If this occurs, close the water tap and
contact the authorized service center for
information to replace the hose.
3/4”
3/4”
A
A
A
5. Connect the other end of the COLD water
inlet hose to the cold water tap with 3/4"
thread.
WARNING!
The inlet water shall not exceed 25 °C.
Water drainage
The drain hose should stay at a height of no
less than 60 cm and not more than 100 cm.
You can extend the drain hose to
maximum 400 cm. Contact the
authorised service centre to buy the other
drain hose and the extension.
ENGLISH 9

AEG 5000 Series Specifications

General

Category	Freezer
Type	Upright
Climate Class	SN-T
Door Hinge	Right
Reversible Door	Yes