8
Operating the appliance
Switching the appliance on and off
Selecting the cooking zone
3 The decimal point is displayed by the selected cooking zone. Then a
heat setting must be set for this cooking zone within 6 seconds, other-
wise it must be re-selected.
Selecting the heat setting
3 After selecting the cooking zone, briefly release the sensor field .
3 After 6 seconds with no input the selection is cancelled and the deci-
mal point goes out. To set the required cooking zone again, make an-
other selection.
Control panel Display
Switch on Touch for 2 seconds. ¾ / Decimal point flashes
Switch off Touch for 1 second h / none
Control panel Display
Select Touch ¾ Decimal point illumi-
nates
Control panel Display
Increase Touch ¾ to Ç
Decrease Touch Ç to ¾
Switch off Touch and at the same time ¾
To Next Page
Loading...
