Problem Possible cause Remedy
The display shows "12.00". There was a power cut. Reset the clock.
There is no good cooking
performance using the Ba-
kingPlus function.
You did not activate the Ba-
kingPlus function.
Refer to "Activating the Ba-
kingPlus function".
There is no good cooking
performance using the Ba-
kingPlus function.
You did not fill the cavity
embossment with water.
Refer to "Activating the Ba-
kingPlus function".
The water in the cavity em-
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110 °C.
Refer to “Hints and tips”
chapter.
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
12. INSTALLATION
WARNING!
Refer to Safety chapters.
12.1 Lifting the appliance
To lift the appliance, do not use the door
handle.
ENGLISH 29
To Next Page
Loading...
