AEG BPS331120M - 11.2 How to remove: Shelf supports; 11.3 How to use: Pyrolytic cleaning

11.2 How to remove: Shelf
supports
Remove the shelf supports to clean the
oven.
Step 1 Turn off the oven and wait un‐
til it is cold.
Step 2 Pull the front of the shelf sup‐
port away from the side wall.
Step 3 Pull the rear end of the shelf
support away from the side
wall and remove it.
2
1
Step 4 Install the shelf supports in
the opposite sequence.
The retaining pins on the tele‐
scopic runners must point to
the front.
11.3 How to use: Pyrolytic
cleaning
Clean the oven with pyrolytic cleaning.
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as this
function. It can cause
damage to the oven.
Before the pyrolytic cleaning:
Turn off the oven and
wait until it is cold.
Remove all accessories and
removable shelf supports.
Clean the oven floor and the in‐
ner door glass with warm water,
a soft cloth and a mild deter‐
gent.
Step 1
Set the function: . - flashes.
Step 2
, - press to set the cleaning mode.
Option Cleaning mode Duration
P1 Light cleaning 1 h 30 min
P2 Normal cleaning 3 h
ENGLISH 31