control bars on the left side.
Correct cookware position:
Incorrect cookware position:
FlexiBridge Big Bridge mode
To activate the mode press until you
see the correct mode indicator . This
mode connects the three rear sections
into one cooking area. The front section
is not connected and operates as a
separate cooking zone. You can set the
heat setting for each area separately.
Use the two control bars on the left side.
Correct cookware position:
Make sure to place the cookware on the
three connected sections. If you use
cookware smaller than two sections the
control bar blinks and after 2 minutes the
zone deactivates.
Incorrect cookware position:
FlexiBridge Max Bridge mode
To activate the mode press until you
see the correct mode indicator
. This
mode connects all sections into one
cooking area. To set the heat setting use
any of the two control bars on the left
side.
Correct cookware position:
Make sure to place the cookware on the
four connected sections. If you use
cookware smaller than three sections the
control bar blinks and after 2 minutes the
zone switches off.
ENGLISH 19
To Next Page
Loading...
