AEG DC7003000 - What to Do If...; Troubleshooting Oven Issues

Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2. Pull the door trim to the front to re-
move it.
3. Hold the door glass panels on their top edge one by one and pull them upwards out of
the guide
4. Clean the door glass panels.
To install panels follow the procedure in reverse. Insert the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem Possible cause Solution
The oven does not heat up The appliance is switched off Switch on the appliance
The oven does not heat up The clock is not set Set the clock. Refer to "Setting
the clock"
The oven does not heat up The necessary settings are not
set
Make sure, the settings are cor-
rect
The oven does not heat up The automatic cut-out is
switched on
Refer to "Automatic cut-out"
B
28 What to do if…