34
For contractors
s $IRECTTAPINSTANTANEOUSWATERHEATERS
ADEo 70 WD - mono-lever mixer tap with changeover bath/hand shower
Part no. 183934
s )NSTALLATIONACCESSORIES
Pipe assembly undersink installation UT 104
Part no. 184421
Water connections with 12 mm compression fittings
s 5NIVERSALMOUNTINGFRAME
Part no. 227701
Comprising:
– Mounting frame with
– electrical wiring.
This assembly creates a gap of 30 mm between the device back panel and the installation wall.
This enables the electrical connection to be routed over unfinished walls at any point behind the
equipment. This increases the equipment depth by 30 mm. This set reduces the protection to IP 24 (splash-
proof).
s /FFSETINSTALLATIONSETFORUNlNISHEDWALLS
Part no. 227702
Comprising:
– Universal mounting frame (for specification see part no. 227701).
– Pipe bends for a vertical offset of the device relative to the water connection by 90 mm downwards.
s 0IPEASSEMBLYREPLACEMENTOFAGASlREDWATERHEATER
Part no. 227703
Comprising:
– Universal mounting frame (for specification see part no. 227701)
- Pipe bends for the installation with existing gas water heater connections (cold water on the left and
DHW on the right).
s !UTOMATICMAXIMUMDEMANDCONTROLLER,2!
Part no. 001786
Priority control of the instantaneous water heater when operating, for example, electric storage heaters
simultaneously. For connection of the LR 1-A, see
L
.
s !CCESSORIESFOROPERATIONOFA$$,%,#$WITHPREHEATEDWATER ZTA 3/4 – central thermostatic valve
Part no. 073864
By adding cold water via a bypass pipe, the central thermostatic valve installed immediately above the
storage water cylinder guarantees that the outlet.
8. Special accessories
To Next Page
Loading...
