33
When the wash programme is complete
When a wash programme is complete, PLEASE TAKE OUT THE CLOTHES
will appear in the display.
3 If you do not press any buttons or press the control knob within three
minutes of the programme finishing, the washing machine will switch
into standby mode. The stand-by mode is cancelled by pressing one of
the buttons or turning the knob.
3 If EASY IRON has been selected, a crease prevention cycle of approx. 30
minutes takes place after the programme has ended. You can remove
the washing at any time during the crease prevention cycle. To do this,
press the PAUSE button and the door can be opened.
For rinse hold
If the wash cycle was ended with a rinse hold, the water must first be
drained and if necessary the washing spun:
Spin:
1. Set the desired spin speed.
2. Press the START button.
The washing will be spun.
Short spin or drain:
1. Switch the appliance off and
then on again.
2. Using the control knob,
either
– highlight SHORT SPIN
(reduce spin speed if re-
quired) or
– highlight DRAIN.
DELICATES 30°C
RINSE HOLD 11:25-11:28
N§
START
RINSE HOLD
###############
RINSE H.
MOISTURE 97 %
DELICATES 30°C
1000 RPM 11:25-11:28
N§
START
RINSE HOLD
###############
1000
MOISTURE 97 %
SHORT SPIN
800 RPM 11:25-11:28
ú
START
FASHION
SHORT SPIN)
800
SPIN
STARCH
OPTIONS DRAIN
To Next Page
Loading...
Need help?
General
