7.3 Programme dial
For selecting the desired washing
programme. Refer to 'Programmes' chapter
for more details.
The position is a "Reset" function, which
stops and resets the running programme. The
display shows empty dashes to indicate that
no programme was selected.
7.4 Tempe. °C
When you select a washing programme, the
appliance automatically proposes a default
temperature.
The indicator Frío/Fria = cold water.
The indicator of the set temperature comes
on.
7.5 Centrif.
When you set a programme, the appliance
automatically sets the default spin speed
allowed for each programme.
By means of this button, you can change
the default spin speed or set one of the
additional spin options:
• Aclarar sin drenaje/Enxaguar sem
escoar . The related indicator comes
on.
The final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The door stays locked and the drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
If you touch the Inicio/Pausa button, the
appliance performs the spinning phase
and drains the water.
• Sin Centrif./Sem Centrif.
. The related
indicator comes on.
Set this option to deactivate all spin
phases. The appliance performs only the
draining phase of the selected washing
programme. Set this option for very
delicate fabrics. The rinse phase uses
more water for some washing
programmes
• Night . The related indicator comes on.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the drum.
This helps to reduce creasing. The door
stays locked. The drum turns regularly to
reduce creasing. You must drain the water
to unlock the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available. In
some programmes the rinses are
performed with more water.
If you touch the Inicio/Pausa button, the
appliance performs only the draining
phase.
The appliance empties the water out
automatically after approximately 18
hours.
7.6 Pre-Lava.
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the touch
button illuminates.
Use this option to add a pre-wash phase at
30 °C before the washing phase.
This option is recommended for heavily soiled
laundry, especially if containing sand, dust,
mud and other solid particles.
The option can increase the programme
duration.
7.7 Permanent Anti-stain
This option adds an anti-stain phase to the
programme. Use this option for laundry with
hard stains to remove.
To activate/deactivate this option, hold the
Pre-Lava. button pressed for 3 seconds until
the indicator
comes on/goes off on the
display.
Pour the stain remover into compartment .
20 ENGLISH
To Next Page
Loading...
