AEG Light - CHANGE THE SYSTEM PIN




Page
21 

8.2.2 Setthehandsetpriority
Whenyouhavemorethanonehandsetregisteredtothebasestation,youcansetwhichhandsettoringfirst
beforetheothers.
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectHandsetPriority.
3.Press<OK>and<UP/DOWN>tochooseSelectHandset.
4.Press<OK>and<LEFT/RIGHT>toselectwhichhandsettogettheprioritytoringfirst.
Note:IfAllHandsetsischosen,alltheregisteredhandsetswillringatthesametimeandpress<OK>toconfirm.
5.Press<OK>and<LEFT/RIGHT>toselectthenumberofringdelay(2Rings/4Rings/6Rings/8Rings).
6.Press<OK>toconfirm.
8.2.3 Setthedialmode
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectDialMode.
3.Press<OK>and<LEFT/RIGHT>toselectToneorPulse.
4.Press<OK>toconfirm.
8.2.4 Settheflashtime
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectFlashTime.
3.Press<OK>and<UP/DOWN>toselectthedesiredflashtime.
Note:
Flashtimeoptionsarecountrydependent.
4.
Press<OK>toconfirm.
8.2.5 Setdateandtime
InIdle:
1.Press<Menu>and<4-waykey>toselectBaseSettings.
2.Press<OK>and<UP/DOWN>toselectDate/Time.
3.Press<OK>and<LEFT/RIGHT>toselect12houror24hourformat.
4.Press<DOWN>and<LEFT/RIGHT>toselectdd/mmormm/dddateformat.
5.Press<DOWN>toenterthetime.Duringtimeinput,press<#>totogglebetweenAMorPMif12hourtime
formatisselected.
6.Press<DOWN>toenterthedate.
7.Press<OK>toconfirm.
8.2.6 ChangethesystemPIN
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectSystemPIN.
3.Press<OK>toentertheold4-digitsystemPIN.
4.Press<OK>toenterthenew4-digitsystemPIN.
5.Press<OK>toenterthenew4-digitsystemPIN.
6.Press<OK>toreconfirmandsavethenew4-digitPIN.
Note:IfthePINisincorrect,“INCORRECTPIN”willdisplaywithanerrortoneinthescreen.
8.2.7 Setanexchangecode
Youcansetanexchangecodeforyourhandsetsuchthatapausewillbeinsertedafterthefirstdigitifitmatches
withtheexchangecode.ThisfeatureisespeciallyusefulforPBXsystems.
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectExchangeCode.
3.Press<OK>toentertheexchangecode.
4.Press<OK>toconfirm.
Note:
Onlyonedigitisallowedtoenterfortheexchangecode.
