AEG Light - INSTALL YOUR PHONE; CONNECT THE BASE STATION; INSTALL AND CHARGE THE BATTERIES




Page
5 

2 INSTALLYOURPHONE
2.1 ConnecttheBaseStation

1) Plugthepowersupply
&linecord intothebasestation.
2) Plugthepowersupply&linecordintothewallsocket.
3) Thebaseindicatorlightsup.Theansweringmachineisswitchedon.
4) Alwaysusethecablesprovidedinthebox.


2.2 InstallandChargetheBatteries
1) Slideoutthebatterycompartmentcover.
2) Placethesuppliedbatterypackasindicated.Locatethebatteryleadandconnectorandplugitintothe
socketinsidethebatterycompartment(theredwireshouldbeontheleft).Tuckthebatteryleadsinthe
spaceabovethebattery.
3) Slidethebatterycompartmentcoverback.
4) Putthehandsetonthebaseandchargethebatteryfor14hoursfirsttime.Abeepindicatesthatthe
handsetisproperlyplacedonthebaseorcharger.

UseonlytheNiMHbatterypackprovided.



















