AEG Light - RESET THE BASE SETTINGS TO DEFAULT SETTINGS




Page
22 


8.2.8 ActivatetheECOmode(Optional)
Yourtelephoneisprovidedwithalow-emissionmode.ECOmodeisactivated,assoonasyouplacethehandset
inthebasestation,thetransmissionpowerbetweenhandsetandbasestationisreducedtotheminimum.This
appliestobasewithsinglehandsetregistrationonly.Ifmorethanonehandsetisregisteredtothebasestation,the
ECOmodewillnotfunction.
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectECOMode.
3.Press<OK>toselectOntoactivateECOmode.
4.Press<OK>toconfirm.
8.2.9 Resetthebasesettingstodefaultsettings
Aftersystemreset,thephonewillreturntoitsoriginalsettings.
InIdle:
1.Repeatstep1insection
8.2.1.
2.Press<OK>and<UP/DOWN>toselectSystemReset.
3.Press<OK>toenterthe4-digitSystemPIN.
Note:4-digitPINisenteredin****.Once4digitsareentered,therightsoftkeywillbecomeOK.
4.Press<OK>and<YES>toconfirmresettingthebasesettingstodefaultsettings.
Thebasewillrestoretodefaultsettingsandreturntostandby.





9 DEFAULTSETTINGS

Items DefaultValues
 
CallList 
AllCallsorUnansweredCallsOnly AllCalls
NewCallAlert On
 
Sound 
ExternalRingerMelody Melody1
InternalRingerMelody Melody2
RingerVolume Level3
Silence Off
KeyBeepTone On
ConfirmationTone On
LowBatteryTone On
OutofRangeTone On
 
HandsetSettings 
DirectCall Off
Contrast Level5
HandsetRename Empty
Wallpaper Wallpaper1
ColourTheme Theme1
Language CountryDependent
AutoAnswer On
 
BaseSettings 
RingerMelody Melody1
RingerVolume Level2
HandsetPriority AllHandsets
DialMode Tone
FlashTime CountryDependent