9.2 Child Lock
With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option, touch
the and the buttons
simultaneously until the indicator
comes on/goes off on the display.
You can activate this option:
• After you touch the Start/Pause button: all
the buttons and the programme dial are
deactivated (except On/Off button ).
• Before you touch the Start/Pause button:
the appliance cannot start.
The appliance keeps the selection of this
option after you switch it off.
9.3 Soft Plus
Set the Soft Plus option to optimise the fabric
softener distribution and improve the fabric
softness.
It is suggested when you use the fabric
softener.
This option increases slightly the
programme duration.
To activate/deactivate this option touch the
button and the button simultaneously
until the indicator comes on/goes off
above the indicator.
9.4 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
• To activate/deactivate this option touch
the button and the button
simultaneously until the indicator of the
Extra Rinse button comes on/goes off.
9.5 Operating Hours Counter
It is possible to visualise the total operating
time of the appliance in hours, starting from
the first switching on. This value will count
operating time of the cycles (does not include
pauses, delayed start time). To visualise this
value, proceed as follows:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the Eco
40-60 programme (1st position
clockwise).
3. Press and hold the and buttons
for some seconds (within 10 seconds
after the switching on. After these 10
seconds, the key combination activates
and deactivates the acoustic signals).
4. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens and
units).
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
9.6 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Turn the programme knob to the
Synthetics programme (3rd position
clockwise).
3. Press and hold the and buttons
for some seconds (within 10 seconds
after the switching on. After these 10
seconds, the key combination activates
and deactivates the acoustic signals).
4. The display will show for about 5
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
20 ENGLISH
To Next Page
Loading...
