increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case of
drum overload, the indicator is
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
• About 20 minutes after the
programme start, the programme
duration could be adjusted again
depending on the capacity of water
absorption of the fabrics.
• The ProSense detection is carried out
with complete washing programmes
only (no skipping phase selected).
• The ProSense is not available with
programmes with short cycles and
without washing phase.
• The appliance can play a double beep
to indicate overload or unevenly
distributed load. The tune sounds if
acoustic signals are not disabled.
11.13 Opening the Lid when the
programme operates
CAUTION!
If the temperature and level of the water
in the drum are too high, the lid lock
indicator stays on and you cannot
open the lid.
To open the lid proceed as follows:
1. Press the button On/Off for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
To open the appliance lid:
1. Press button Start/Pause.
The lid lock indicator
goes off.
2. Open the appliance lid.
3. Close the lid and press button Start/
Pause.
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The acoustic
signal operates (if it is active).
In the display comes on and the lid locked
indicator
goes off.
The indicator of Start/Pause button goes off.
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew and
odours
11.16 Draining water out after end
of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
24 ENGLISH
To Next Page
Loading...
