AEG Protect A. 1000 - Charging; Computer connection

12
4.3 Charging
This unit is shipped from the factory with its internal battery
fully charged, however, some power may be lost during
shipping and the battery should be recharged prior to use.
Plug the unit into an appropriate power supply and allow the
UPS to charge fully by leaving it plugged in for at least 8
hours with no load (no electrical devices such as computers,
monitors, etc.).
4.4 Computer connection
Connect one computer-related device to each of the power
sockets found on the back of the UPS.
4.5 Data lines protection
Plug the incoming internet line into the “In” socket at the back
of the PROTECT A. UPS.
In
coming phone, fax,
modem line
8 hours